美能达1060/2060/3070报错代码C-3508,C3508解决方法
更新时间:2024/4/19 5:10:35,view:92苏州美能达打印机售后维修服务中心电话0512-696l6769
美能达1060/2060/3070报错代码C-3508,C3508解决方法
Cause
Paper is wound around the fusing roller.
J3102 occurs 4 times in a row.
Resolution
Make sure no paper is stuck in the top part of the fuser.
The Service mode is accessible by entering Utility = Stop = 0 = Stop = 0 =; 0 = 1. This is to prevent accidental reset of the code and causing additional damage to the machine.
To reset a fuser abnormality code, perform the following:
Then you will need to follow below to reset the dip switch on the machine.
Power the machine OFF from the main switch leaving the sub switch ON.
Turn main power switch ON while pressing the Utility/Counter key. Keep holding it till the comes up in Service mode.
Press [03 System Setting] on the touchscreen.
Press [01 Software SW setting] on the touchscreen.
Press the left up-arrow, which is displayed on the touchscreen, 2 times. The number displayed above the up-arrow will change to 03.
Select the bit number of switch 1, using the right up-arrow, 03-1 will be indicated.
Press the [Return] key, which is displayed on the touchscreen.
Exit Service mode to return to normal operation
苏州美能达打印机维修站电话696l6769,企业一站式服务,上门维修,耗材配送
Cause
Paper is wound around the fusing roller.
J3102 occurs 4 times in a row.
Resolution
Make sure no paper is stuck in the top part of the fuser.
The Service mode is accessible by entering Utility = Stop = 0 = Stop = 0 =; 0 = 1. This is to prevent accidental reset of the code and causing additional damage to the machine.
To reset a fuser abnormality code, perform the following:
Then you will need to follow below to reset the dip switch on the machine.
Power the machine OFF from the main switch leaving the sub switch ON.
Turn main power switch ON while pressing the Utility/Counter key. Keep holding it till the comes up in Service mode.
Press [03 System Setting] on the touchscreen.
Press [01 Software SW setting] on the touchscreen.
Press the left up-arrow, which is displayed on the touchscreen, 2 times. The number displayed above the up-arrow will change to 03.
Select the bit number of switch 1, using the right up-arrow, 03-1 will be indicated.
Press the [Return] key, which is displayed on the touchscreen.
Exit Service mode to return to normal operation
苏州美能达打印机维修站电话696l6769,企业一站式服务,上门维修,耗材配送
热门图文