美能达5501/6501报错代码C-0201,C0201解决方法
更新时间:2024/4/17 4:16:05,view:121美能达打印机苏州美能达打印机售后维修服务中心电话0512-696l6769,苏州美能达维修点电话, 美能达246显示C6101, 美能达c0211, 柯尼卡美能达废粉盒更换, 美能达c0211, 震旦复印机故障c2557处理方法美能达,
美能达5501/6501报错代码C-0201,C0201解决方法
Cause
Tray 1 failure C-0201
Tray 2 failure C-0202
Tray 3 failure C-0203
Tray 4 failure C-0204
Tray 5 failure C-0205
Resolution
Check that no paper is caught between tray 1 and the entrance to the machine.
If no paper is caught follow below to disable the tray so that you can continue to print from other trays.
Power the machine OFF from the main switch leaving the sub switch ON.
1.Turn main power switch ON while pressing the Utility/Counter key. Keep holding it till the comes up in Service mode.
2.Press [03 System Setting] on the touchscreen.
3.Press [01 Software SW setting] on the touchscreen.
4.Press the left up-arrow, which is displayed on the touchscreen, 2 times. The number displayed above the up-arrow will change to 18.
5.Select the bit number of switch 0, using the right up-arrow, 18-0 will be indicated.
6.Turn the setting to ON. To disable further trays use these DIPSW settings....
Tray1 - 18-0 to 1
Tray2 - 18-1 to 1
Tray3 - 18-2 to 1
Tray4 - 18-3 to 1
7.Press the [Return] key, which is displayed on the touchscreen.
8.Exit Service mode to return to normal operation 苏州美能达打印机维修站电话696l6769,企业一站式服务,售后,耗材配送
Cause
Tray 1 failure C-0201
Tray 2 failure C-0202
Tray 3 failure C-0203
Tray 4 failure C-0204
Tray 5 failure C-0205
Resolution
Check that no paper is caught between tray 1 and the entrance to the machine.
If no paper is caught follow below to disable the tray so that you can continue to print from other trays.
Power the machine OFF from the main switch leaving the sub switch ON.
1.Turn main power switch ON while pressing the Utility/Counter key. Keep holding it till the comes up in Service mode.
2.Press [03 System Setting] on the touchscreen.
3.Press [01 Software SW setting] on the touchscreen.
4.Press the left up-arrow, which is displayed on the touchscreen, 2 times. The number displayed above the up-arrow will change to 18.
5.Select the bit number of switch 0, using the right up-arrow, 18-0 will be indicated.
6.Turn the setting to ON. To disable further trays use these DIPSW settings....
Tray1 - 18-0 to 1
Tray2 - 18-1 to 1
Tray3 - 18-2 to 1
Tray4 - 18-3 to 1
7.Press the [Return] key, which is displayed on the touchscreen.
8.Exit Service mode to return to normal operation 苏州美能达打印机维修站电话696l6769,企业一站式服务,售后,耗材配送
热门图文