东芝2303AM换过载体初始化完后，重新开机后报C414
更新时间：2024/4/26 6:24:54,view:246东芝打印机2303AM苏州东芝打印机售后维修服务中心电话0512-696l6769，苏州东芝维修点电话, 东芝4618A复印机打印重影, 东芝300d一直显示前盖打开, 东芝C415报错, 东芝306故障代码ce90, 东芝提示预热中,
东芝2303AM换过载体初始化完后，重新开机后报C414，不能工作
维修手册,故障代码,技术通报 
技术 仁和数码 发表于 2022/8/13 C414], perform the following:
1. Turn ON the power while [0] , [8] are pressed simultaneously.
2. Key in "2002", then press [START].
3. Change the current status counter value "1" , "2" to "0", then press [OK] (to cancel [C413 / C414]).
4. Turn the power OFF , then back ON. Make sure that the equipment enters the normal ready state.
维修手册,故障代码,技术通报
·C414定影器故障，跟换载体没关系
·Code C414
Description Fuser unit related service call. Thermistor abnormality during warming up or in ready status after abnormality judgment.
Causes MAIN board Thermistors Heater lamp
苏州东芝2303AM售后维修电话696l6769，企业一站式服务，上门维修，耗材配送
1. Turn ON the power while [0] , [8] are pressed simultaneously.
2. Key in "2002", then press [START].
3. Change the current status counter value "1" , "2" to "0", then press [OK] (to cancel [C413 / C414]).
4. Turn the power OFF , then back ON. Make sure that the equipment enters the normal ready state.
东芝2303a请设置正确的纸东芝请设置正确的纸 东芝苏州售后维修服务电话前沿数码 东芝复印机怎么取消节能模式 东芝苏州售后维修服务电话曹闩淞 +开机是省电模式是睡眠模式...把值设为就不休眠......
东芝2303初始化载体值为145 东芝初始化载体值为，右下角的数值调多少合适 默认值是 左右就不会报错，值越大耗粉量越大 左右都正常 苏州东芝打印机维修站电话，企业一站式服务，上门维修，耗材配送 ...
»东芝2303初始化载体值为145
热门图文